Keeping Wet Zones Warm Without the Headache
Let’s be honest: locker rooms and wash-down bays are usually miserable. They’re cold, damp, and the last place anyone wants to hang out. We build IP65-rated infrared heaters specifically for these kinds of spots—places where water splashes are just part of the job. Instead of trying to warm up all the air in a drafty room (which takes forever and usually doesn’t work), we use shortwave infrared. It works more like the sun. You feel the heat on your skin the second you step under it. It’s instant. Why it actually works Most heaters have a “warm-up” period. You turn them on and then… you wait. We hate that. We use quartz elements that hit their peak temperature almost immediately. No lag, no waiting for oil to heat up. By packing a lot of power into a small space, we create a concentrated beam of heat. You get warm right now, even if the rest of the room is still freezing. Dealing with the water Water and electricity are a terrible mix. To get that IP65 rating, we basically armor the internals. The heating elements and all the wiring live inside a corrosion-resistant shell. We use heavy-duty, high-temp gaskets and sealed cable entries. This keeps dust and water jets from getting anywhere they shouldn’t. You’ll notice the casing is usually polished aluminum or stainless steel. It’s not just to make it look sharp. Those shiny surfaces act like a mirror, bouncing the heat forward so it actually reaches you instead of wasting energy heating up the back of the unit. A few things to keep in mind These units pull a lot of power. Before you install them, double-check your wiring and breakers to make sure they can handle that initial surge. And here’s a pro tip: because the housing is so well-sealed against water, it can trap heat around the electrical terminals. We use high-temp wiring so the insulation doesn’t get brittle and crack over time. Just be careful not to cram them into a tiny space with zero airflow. If the housing gets too hot, it can wear out the capacitors in your control circuit faster than you’d like. Give them a little room to breathe, and they’ll last a lifetime.